Hi,
I have problem with WrpTool. I modified Nogova, but when I compilled it, run OFP and choosed my new island, it started loading, but it took about 10 minutes until it loaded. And then it crashed to windows :-/
What to do?
OFP loads one island 10 minutes
Moderators: Lone Wolf, Snake Man
-
- Newbie
- Posts: 7
- Joined: 2005-11-19 12:05:19
OFP loads one island 10 minutes
Last edited by BoborSK on 1970-01-01 00:00:00, edited 1 time in total.
Re: OFP loads one island 10 minutes
So what did you modify then? What does your config.cpp for the new island look like?I have problem with WrpTool. I modified Nogova
-
- Newbie
- Posts: 7
- Joined: 2005-11-19 12:05:19
Re: OFP loads one island 10 minutes
Hm, there wasnt problem with cpp
I fixed it, I tried to binarize and it works fine
But theres another problem: I placed some buildings from Data3D, they were alligned to ground, but when I tried it in OFP, they floated a bit...
The problem is, that these objects have their "underground part", but WRPTool place them higher, so u can see this underground part. (I hope, that I explained it good, I dont speak english very well )
I fixed it, I tried to binarize and it works fine
But theres another problem: I placed some buildings from Data3D, they were alligned to ground, but when I tried it in OFP, they floated a bit...
The problem is, that these objects have their "underground part", but WRPTool place them higher, so u can see this underground part. (I hope, that I explained it good, I dont speak english very well )
Last edited by BoborSK on 1970-01-01 00:00:00, edited 1 time in total.
Who is online
Users browsing this forum: Bing [Bot], ClaudeBot [Bot] and 0 guests